The UPA-2...it's all about possibilities. A dynamic, high current Class A/B amplifier with a surprisingly modest price. Its advanced feature set makes it versatile enough for multiple applications.
1. A STAND-ALONE, AUDIOPHILE GRADE TWO CHANNEL AMPLIFIER
The UPA-2 is no toy. Inside the compact 2RU chassis are two of the same amp modules used in our UPA-7. They are horizontally mounted and driven by a high-current toroid transformer power supply. Built with the same high-quality/low noise standards as all Emotiva amplifiers, the UPA-2 is a reference level two channel power amplifier.
2. SYSTEM EXPANSION
• Boost your AVR: Receiver amplifiers face the limitations of the small space (and budgets) they are designed to work with, generally lacking the deep power reserves necessary for high quality sound. Add a UPA-2 to your existing setup, using it to drive your main left and right speakers. You'll instantly notice and appreciate greater dynamics, detail and headroom...and earn your receiver's thanks!
• Ideal building blocks for a growing Home Theater/Surround system: Upgrading from a 5.1 to a 7.1? It's never been simpler or more affordable. The UPA-2 is a perfect companion piece to an XPA-5 or XPA-3.
3. ZONE 2 AMPLIFICATION
Single or multiple UPA-2's are perfect for powering speakers throughout your household. Poolside. Kitchen. Dining room. Anywhere. The UPA-2's affordabe price, flexible design, and preamp in/out loop (for daisy chaining) along with individual level controls put you in control.
Power output:
• 8 Ohms = 125 watts RMS per channel (2)
• 4 Ohms = 185 watts RMS per channel (2)
• Frequency Response: +/- 0.1 db: 20 to 20Khz
• Broadband Frequency Response: -3db 10hz - 150khz
• Signal to Noise Ratio: (Un-weighted): >100db
|
 |
• Distortion (THD, 80Khz bandwidth): 0.007
• Discrete, dual differential class AB amplifier topology with active current sources
• Low noise toroidal power transformer
• On Semiconductor output devices
• Damping Factor: Approximately 200 into 8 ohms
• Gain: Channels : 0-32db (adjustable)
• Input Impedance: 47K ohm
• External Trigger: 3-12 Volts DC (tip positive)
• DC Offset: <1mV servo corrected
• Crosstalk: >80db
• Fully protected from all fault conditions
• External trigger input/output (5-12 Volts DC - tip positive)
• Output/Level control
• Preamp in/out loop for daisy chaining
• Soft touch power switch
• 2RU chassis w/ solid milled aluminum faceplate
• IEC power inlet, 120/230 VAC configurable
• 17” W x 3 7/8” H (3.46" without feet ) x 18" D (including rear terminals/binding posts -16.7" from front to back plate)
• Weight: 30 lbs /13.6 kg. Shipping weight (with packaging): 39lbs /17.7kg
UPA-2 MANUAL
(PDF)
Endless possibilities. The UPA-2. |
